[dms-discuss] Printer Guess
Robert Nickerson
rob at omsoft.com
Thu Aug 31 14:45:25 PDT 2017
HooraY!
RAN
On 8/30/2017 9:38 PM, Roland Synnestvedt wrote:
> ( that is supposed to be a 10mm x 10mm cube btw)
>
> On Aug 30, 2017 9:12 PM, "Roland Synnestvedt" <rsynnest at gmail.com
> <mailto:rsynnest at gmail.com>> wrote:
>
> Hi Rob,
>
> I'm not sure if you already figured out the firmware etc but I was
> able to print today! I'm using the Repetier-Host AppImage and the
> Prusa fork of Slic3r Appimage (AppImage is the recommended runtime
> for both programs). I can do a write-up later this week but the
> executables are located in ~/home/threed/AppImages and can be run
> via command line or double click (they are also in the system menu
> but so is the old repetier installation which I think is bad), run
> them without sudo (sudo can be problematic for graphical programs).
> The config is called "roland prusa i3", 250000 baud appears to be
> working. The printer does need a new bed (a simple wood block),
> the mdf is falling apart and uneven so I had to wedge some paper
> under it to get the z axis right. It definitely still needs some
> tweaking, but behold the almighty glory of the futuristic
> technology now in our posession!! (attached)
>
> -Roland
>
>
> On Aug 28, 2017 8:37 PM, "Robert Nickerson" <rob at omsoft.com
> <mailto:rob at omsoft.com>> wrote:
>
> Hi
>
>
> I think we have the printer at 250000 baud but mono on linux
> wont go over 115200 baud
>
>
> https://github.com/repetier/Repetier-Host/issues/156
> <https://github.com/repetier/Repetier-Host/issues/156>
>
>
> I tried to get the new marlin firmware uploaded with the lower
> baud rate buit tried to verify the sketch and it wouldnt
> verify, or I guess there is a mono patch to allow other baud
> rates.
>
>
> Not so much luck and too hot by the printer.
>
> Close !
>
>
> --
> Robert Nickerson
> UCD Class of 1996
> CEO, Om Networks
>
> cell: 5308483865 <tel:5308483865>
> www.omsoft.com <http://www.omsoft.com>
>
> _______________________________________________
> Davis Makerspace Discuss mailing list
> Discuss at lists.davismakerspace.org
> <mailto:Discuss at lists.davismakerspace.org>
> http://lists.davismakerspace.org/listinfo/discuss
> <http://lists.davismakerspace.org/listinfo/discuss>
>
>
>
>
> _______________________________________________
> Davis Makerspace Discuss mailing list
> Discuss at lists.davismakerspace.org
> http://lists.davismakerspace.org/listinfo/discuss
--
Robert Nickerson
UCD Class of 1996
CEO, Om Networks
cell: 5308483865
www.omsoft.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.davismakerspace.org/pipermail/discuss/attachments/20170831/c0b04723/attachment.html>
More information about the Discuss
mailing list