[dms-discuss] Printer Guess

[Emily Schleiner]

🍾

On Thu, Aug 31, 2017 at 2:45 PM, Robert Nickerson <rob at omsoft.com> wrote:

> HooraY!
>
> RAN
>
> On 8/30/2017 9:38 PM, Roland Synnestvedt wrote:
>
> ( that is supposed to be a 10mm x 10mm cube btw)
>
> On Aug 30, 2017 9:12 PM, "Roland Synnestvedt" <rsynnest at gmail.com> wrote:
>
>> Hi Rob,
>>
>> I'm not sure if you already figured out the firmware etc but I was able
>> to print today! I'm using the Repetier-Host AppImage and the Prusa fork of
>> Slic3r Appimage (AppImage is the recommended runtime for both programs). I
>> can do a write-up later this week but the executables are located in
>> ~/home/threed/AppImages and can be run via command line or double click
>> (they are also in the system menu but so is the old repetier installation
>> which I think is bad), run them without sudo (sudo can be problematic for
>> graphical programs).
>> The config is called "roland prusa i3", 250000 baud appears to be
>> working. The printer does need a new bed (a simple wood block),  the mdf is
>> falling apart and uneven so I had to wedge some paper under it to get the z
>> axis right. It definitely still needs some tweaking, but behold the
>> almighty glory of the futuristic technology now in our posession!!
>> (attached)
>>
>> -Roland
>>
>>
>> On Aug 28, 2017 8:37 PM, "Robert Nickerson" <rob at omsoft.com> wrote:
>>
>> Hi
>>
>>
>> I think we have the printer at 250000 baud but mono on linux wont go over
>> 115200 baud
>>
>>
>> https://github.com/repetier/Repetier-Host/issues/156
>>
>>
>> I tried to get the new marlin firmware uploaded with the lower baud rate
>> buit tried to verify the sketch and it wouldnt verify, or I guess there is
>> a mono patch to allow other baud rates.
>>
>>
>> Not so much luck and too hot by the printer.
>>
>> Close !
>>
>>
>> --
>> Robert Nickerson
>> UCD Class of 1996
>> CEO, Om Networks
>>
>> cell: 5308483865
>> www.omsoft.com
>>
>> _______________________________________________
>> Davis Makerspace Discuss mailing list
>> Discuss at lists.davismakerspace.org
>> http://lists.davismakerspace.org/listinfo/discuss
>>
>>
>>
>
> _______________________________________________
> Davis Makerspace Discuss mailing listDiscuss at lists.davismakerspace.orghttp://lists.davismakerspace.org/listinfo/discuss
>
>
> --
> Robert Nickerson
> UCD Class of 1996
> CEO, Om Networks
>
> cell: 5308483865 <(530)%20848-3865>www.omsoft.com
>
>
> _______________________________________________
> Davis Makerspace Discuss mailing list
> Discuss at lists.davismakerspace.org
> http://lists.davismakerspace.org/listinfo/discuss
>
>


-- 
__________________________________
Emily Schleiner
cordial-emily.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.davismakerspace.org/pipermail/discuss/attachments/20170831/33e555a8/attachment.html>