[dms-discuss] Printer Guess

[Roland Synnestvedt]

And thanks to you guys for setting it up!

On Wed, Aug 30, 2017 at 11:00 PM, Ryan McKay <yakcm.nayr at gmail.com> wrote:

> !!!! !!!!!!!! !!!
>
> This is a very exciting development, thanks Roland   ^_^
>
>
> On Aug 30, 2017 9:38 PM, "Roland Synnestvedt" <rsynnest at gmail.com> wrote:
>
>> ( that is supposed to be a 10mm x 10mm cube btw)
>>
>> On Aug 30, 2017 9:12 PM, "Roland Synnestvedt" <rsynnest at gmail.com> wrote:
>>
>>> Hi Rob,
>>>
>>> I'm not sure if you already figured out the firmware etc but I was able
>>> to print today! I'm using the Repetier-Host AppImage and the Prusa fork of
>>> Slic3r Appimage (AppImage is the recommended runtime for both programs). I
>>> can do a write-up later this week but the executables are located in
>>> ~/home/threed/AppImages and can be run via command line or double click
>>> (they are also in the system menu but so is the old repetier installation
>>> which I think is bad), run them without sudo (sudo can be problematic for
>>> graphical programs).
>>> The config is called "roland prusa i3", 250000 baud appears to be
>>> working. The printer does need a new bed (a simple wood block),  the mdf is
>>> falling apart and uneven so I had to wedge some paper under it to get the z
>>> axis right. It definitely still needs some tweaking, but behold the
>>> almighty glory of the futuristic technology now in our posession!!
>>> (attached)
>>>
>>> -Roland
>>>
>>>
>>> On Aug 28, 2017 8:37 PM, "Robert Nickerson" <rob at omsoft.com> wrote:
>>>
>>> Hi
>>>
>>>
>>> I think we have the printer at 250000 baud but mono on linux wont go
>>> over 115200 baud
>>>
>>>
>>> https://github.com/repetier/Repetier-Host/issues/156
>>>
>>>
>>> I tried to get the new marlin firmware uploaded with the lower baud rate
>>> buit tried to verify the sketch and it wouldnt verify, or I guess there is
>>> a mono patch to allow other baud rates.
>>>
>>>
>>> Not so much luck and too hot by the printer.
>>>
>>> Close !
>>>
>>>
>>> --
>>> Robert Nickerson
>>> UCD Class of 1996
>>> CEO, Om Networks
>>>
>>> cell: 5308483865
>>> www.omsoft.com
>>>
>>> _______________________________________________
>>> Davis Makerspace Discuss mailing list
>>> Discuss at lists.davismakerspace.org
>>> http://lists.davismakerspace.org/listinfo/discuss
>>>
>>>
>>>
>> _______________________________________________
>> Davis Makerspace Discuss mailing list
>> Discuss at lists.davismakerspace.org
>> http://lists.davismakerspace.org/listinfo/discuss
>>
>>
> _______________________________________________
> Davis Makerspace Discuss mailing list
> Discuss at lists.davismakerspace.org
> http://lists.davismakerspace.org/listinfo/discuss
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.davismakerspace.org/pipermail/discuss/attachments/20170831/f80ca8cd/attachment-0001.html>