[dms-discuss] Printer Guess

[Roland Synnestvedt]

( that is supposed to be a 10mm x 10mm cube btw)

On Aug 30, 2017 9:12 PM, "Roland Synnestvedt" <rsynnest at gmail.com> wrote:

> Hi Rob,
>
> I'm not sure if you already figured out the firmware etc but I was able to
> print today! I'm using the Repetier-Host AppImage and the Prusa fork of
> Slic3r Appimage (AppImage is the recommended runtime for both programs). I
> can do a write-up later this week but the executables are located in
> ~/home/threed/AppImages and can be run via command line or double click
> (they are also in the system menu but so is the old repetier installation
> which I think is bad), run them without sudo (sudo can be problematic for
> graphical programs).
> The config is called "roland prusa i3", 250000 baud appears to be working.
> The printer does need a new bed (a simple wood block),  the mdf is falling
> apart and uneven so I had to wedge some paper under it to get the z axis
> right. It definitely still needs some tweaking, but behold the almighty
> glory of the futuristic technology now in our posession!! (attached)
>
> -Roland
>
>
> On Aug 28, 2017 8:37 PM, "Robert Nickerson" <rob at omsoft.com> wrote:
>
> Hi
>
>
> I think we have the printer at 250000 baud but mono on linux wont go over
> 115200 baud
>
>
> https://github.com/repetier/Repetier-Host/issues/156
>
>
> I tried to get the new marlin firmware uploaded with the lower baud rate
> buit tried to verify the sketch and it wouldnt verify, or I guess there is
> a mono patch to allow other baud rates.
>
>
> Not so much luck and too hot by the printer.
>
> Close !
>
>
> --
> Robert Nickerson
> UCD Class of 1996
> CEO, Om Networks
>
> cell: 5308483865
> www.omsoft.com
>
> _______________________________________________
> Davis Makerspace Discuss mailing list
> Discuss at lists.davismakerspace.org
> http://lists.davismakerspace.org/listinfo/discuss
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.davismakerspace.org/pipermail/discuss/attachments/20170830/4f5943b0/attachment.html>