[dms-discuss] Looking for a plastic electronics enclosure designer

Jim Stewart jstewart at jkmicro.com
Wed Dec 4 17:20:35 PST 2013


Mark,

I know an industrial designer that sometimes freelances this sort
of stuff.  I'm hesitant to put his email address out on the list without
his permission though.

Feel free to email me at jstewart at jkmicro.com if you'd like to contact
him.

best,
-jim

Top Triode wrote:
> Hi Makers,
>
> This may be a long shot, but anyone out there good with Solid Works or 
> Pro-E or other design tool who has experience designing a 
> snap-together injection molded plastic electronic enclosure? Ideally 
> it could be printed on the 3D printer to make prototype samples, then 
> the final design goes to an injection molding shop. Let me know who 
> can help with this. The enclosure will be very small (about 3 inches 
> by 1 inch by 0.5 inch) and will have mechanical features such as a 
> molded pushbutton that is "hinged" and the snap-together mechanism.
>
> Mark
>
>
> _______________________________________________
> Davis Makerspace Discuss mailing list
> Discuss at lists.davismakerspace.org
> http://lists.davismakerspace.org/listinfo/discuss




More information about the Discuss mailing list