<div dir="ltr">I put some time in to the 3D printers at the space over the past couple days.<div><br></div><div>Tried to improve upon the state of the Prusa i3.  I haven't had too much luck in actually getting it to print much better than before, but I did fix it up with an adjustable bed-leveling system.  That took a lot of time so I actually have more time invested in mechanical fixes than software tweaks on that particular machine as of yet.  Not ready to give up hope on further slicer calibrations (print settings) yielding some improvements as of yet, but I am starting to suspect that there are further mechanical issues to be dealt with (getting some oscillations in the X and Y dimensions from layer to layer... loose belts?) beyond the, now solved, issue of the print bed being super uneven.</div><div><br></div><div>Then I fixed up one of the little wooden guys... got it printing great now, in relative terms.  It's still not as nice as what I'd like it to be, but it's definitely printing better than the Prusa right now.  I'd say we could probably start telling visitors that we actually DO have a functional 3D printer now, instead of the typical "we have some but they're all broken" response... the only potential problem is that this one only has a 12x12x10 cm print volume.  I did all the setup, calibration, and driving of this little guy with my laptop, so maybe tomorrow I'll try to get it running of one of the computers in the space and then transfer over my calibrations.  Once that's done I'll be able to show anyone who's interested how to use it, and I'll probably write up a little quick start guide that could hopefully get a (decently tech-savvy) person from 3D model to 3D print.</div><div><br></div><div><br></div></div>