<div dir="ltr">Hi Everyone,<div><br></div><div>I finally had some free time today and setup the plotter.</div><div>The torx screwdriver for the screws on the back panels is rubber-banded to the printer's user guide<br></div><div>Official error codes for the plotter can be found <a href="http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-bpp03771">here</a></div><div><div>In case anybody else gets similar issues I've outlined my steps for error codes I encountered below:</div></div><div><br></div><div>1. LCD "ERROR 1f50007 Hard Disk Failure"</div><div><blockquote style="margin:0px 0px 0px 40px;border:none;padding:0px">Reading up online said this may be a power supply problem so it may come back<br>Gone after a reboot (power switch at back of printer), never showed up again<br></blockquote>2. LCD: "Boot FAILED Contact HP representative"</div><div><blockquote style="margin:0px 0px 0px 40px;border:none;padding:0px"><div>Gone after another reboot (power switch at the back of the printer)</div></blockquote></div><div>3. LCD stuck at "Spinning up disk..Ok" after repeated reboots</div><div><blockquote style="margin:0px 0px 0px 40px;border:none;padding:0px"><div>Found HP docs <a href="http://h20565.www2.hp.com/hpsc/doc/public/display?sp4ts.oid=82240&docId=emr_na-bpp03893&docLocale=en_US">here</a>, but went through every step with no luck</div></blockquote><blockquote style="margin:0px 0px 0px 40px;border:none;padding:0px">Turned off and unplugged printer, opened hard drive enclosure, took foam holder off hard drive, plugged printer in, turned on printer, and it worked. No idea why.</blockquote>3. LCD: "System error ffffffff 01dc0077 switch off/on if problem persists contact HP support"</div><div><blockquote style="margin:0px 0px 0px 40px;border:none;padding:0px"><div>Rebooted with no luck</div><div>Used HP error code guide, led me <a href="http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-bpp03771#N100B4">here</a></div></blockquote><blockquote style="margin:0px 0px 0px 40px;border:none;padding:0px"><div>Fixed by rebooting with network cable unplugged</div></blockquote></div><div>4. LCD: "Printheads REPLACE"</div><div><blockquote style="margin:0px 0px 0px 40px;border:none;padding:0px"><div>Entered printhead menu to find culprit printhead</div></blockquote></div><div><blockquote style="margin:0px 0px 0px 40px;border:none;padding:0px"><div>Re-seated offending printhead</div></blockquote><br></div><div>After all this was done I was able to follow the media loading guide in the User Manual to load the paper, and the plotter was ready to print! It's in Sleep mode right now, so to turn it on just press the power button on the front.</div><div><br></div><div>-Roland</div></div>