<html>
<head>
<meta http-equiv="content-type" content="text/html; charset=utf-8">
</head>
<body bgcolor="#FFFFFF" text="#000000">
Hi <br>
<br>
1) I'd like to donate some lenses that I got from an old school
maker, Jack Crowell. They clip on your glasses or goggles and have 2
magnifications. <br>
<br>
I put them in the drawer with the solder stuff, if anyone doesnt
want them, just send me an email and I will take them out. <br>
<br>
They are small, and make a good addition to our soldering stuff. So
there you go. <br>
<br>
2) Plus I messed with PrintrbotLC some more. I want to get it going
at Explorit if I can perhaps printing a longer project. I did see
evidence of someone printing on it, but it looked like the job
might have prematuerly terminated. After firing it up it would not
extrude, until I unbolted the filament feed mechanism and pulled
out a bunch of foled up filament, It is now extruding. Then I
started a 2 hour job, and It did stop 17 minutes or so through the
2 hour job just, cold. And it was again clogged and not feeding.
The filament had bent and distorted about 3 cm above where the
extruder nozzle had melted the filament down to the .4mm at the tip.
So I'm wondering what is intermittenelty jamming it and backing it
up and stopping the filament delivery.<br>
<br>
I removed it and further tightened the screws governing tension on
the feed mechanism, and it is now extruding smoothly. <br>
<br>
I dont have time now to run the 2 hour job again, but mabe I will
tomorrow and let jeff take it over at 7. <br>
<br>
I did notice though that the fan is not spinning up at all, though
it looks plugged into power. <br>
<br>
Thoughts? <br>
-- <br>
<div class="moz-signature">
Rob Nickerson <br>
<br>
CEO<br>
Om Networks<br>
UCD Class of 96<br>
C: 530-848-3865<br>
<br>
If we have helped you in a positive way, please give us a good<br>
recommendation at <a href="http://daviswiki.org/Omsoft">daviswiki.org</a>,
and/or <a
href="http://www.yelp.com/biz/omsoft-technologies-davis">yelp.com</a>.<br>
Please like us on <a
href="https://www.facebook.com/omsofttechnologies%22">Facebook</a>.
and put us in your circle at <a
href="https://plus.google.com/+OMSOFTDavis/posts">Google+</a></div>
</body>
</html>